Watersafe Lead Home Drinking Water Test Kit

WaterSafe Drinking Water Test for Lead Detection of lead in your drinking water Kit can detect dissolved lead at levels below the EPA Action Level of 15 parts per billion (ppb) . Contains one lead test strip, one sample vial, and one dropper pipette, as well as a desiccant packet. Single Use AirFilters.com The WaterSafe Drinking Water Test for lead is one test you don't want to miss! Nothing is more critical to your family's health than the detection of lead in your drinking water. This all too common contaminant has been linked to learning disabilities, kidney damage, and muscle disorders. The kit can detect dissolved lead at levels below the EPA Action Level of 15 parts per billion (ppb) . The kit contains one lead test strip, one sample vial, and one dropper pipette, as well as a desiccant packet. Single Use Open foil packet and take out all contents Using dropper pipette, place water sample in the test vial. To pick up sample, tightly squeeze the bulb at the end of the pipette and place the open end into water sample. Release the bulb to pick up sample into vial. Use only one pipette-full of water. Swirl vial gently for several seconds. Place vial on a flat surface. Place the test into test vial, with arrows pointing down Wait 10 minutes. Do not disturb strip or vial during this time. Blue lines will appear on the strip. Take the strip out of the vial and read results: Negative: The LEFT line (next to number 1) is darker than the RIGHT line (next to number 2) Positive: The RIGHT line (next to number 2) is darker than the LEFT line (next to number 1) , or lines are equally dark (Both LEFT and RIGHT lines are equally dark) If no lines appear, or both lines are very light, the test did not run properly and the result is not valid.